• Aluminum top and bottom case
• Sandblasted brass inner weight
• Brass outer weight
• Red alu plate
• Solder or hotswap PCB
• Daughterboard, USB hub PCB, and connector cables
• 50A O-ring (for hotdog mount)
• 6u stab wire
• Hardware for assembly
• AKB feet
• Microfiber cloth
• Carrying case

Specifications

• 7 degrees angle
• Adjusted front height of 18.746 mm (see below, measured from the control key area, not spacebars as that would be a useless measurement)
• 7.8mm plate to top case clearance
• Integrated USB hub – this is on it’s own daughterboard setup, deliberately designed in a modular fashion to be used in other projects
• MX and custom EC PCBs available (EC will come later, this is just an IC, I still need to test)
• 2 piece brass weights
• “Hotdog” (o ring strips) or top mounted
• 1210g built

Solder PCB Layout Support

Hotswap PCB Layout Support